1. Home
  2. Support Frame Z-Brace Mounted Rear Robotics] [Gulfcoast Kit Printers 3D Plus Select Maker and Plus i3 Duplicator Wanhao for
  1. facebook
  2. twitter
  3. linkedin
  4. pinterest
[Gulfcoast Robotics] Rear Mounted Z-Brace Frame Support Kit for Wanhao Duplicator i3 Plus and Maker Select Plus 3D Printers

IMPORTANT: This kit is compatible with PLUS 3D Printer ONLY, for V2.1 3D Printer Zbraces purchase ASIN B07B3X1XH8.

Our new kit is rear mounted and will allow better access to print platform.

In our kit we use ball joints to eliminate any tension created by misalignment between upper and lower bracket. Off shelf M5 ball rod ends are making our Z-brace design simple and clean looking.

Convenient feature of our kit is ability to allow fine adjustment of the each Z-rod length. Z-Brace rod design is based on turnbuckle principle - each rod will extend and contract by turning tube clockwise or counterclockwise. When you are done with adjustment - just tighten counter nuts on each rod end to get rid of any small play and you will make your adjustment permanent. After you tighten counter nuts your frame will become completely solid and stable.




Support Frame Z-Brace Mounted Rear Robotics] [Gulfcoast Kit Printers 3D Plus Select Maker and Plus i3 Duplicator Wanhao for 3D Printer Accessories

by william nagel

the radiator keeps your vehicle's engine cool during a drive; but when your radiator is leaking coolant, the engine can overheat and suffer serious damage. if you are far from a garage and your radiator is leaking, you can use eggs to patch small holes and temporarily plug the leaks. heat from the radiator will cook the egg whites, and pressure will force the eggs into the holes, fixing the leaks long enough to take your car to a garage for repairs.

Support Frame Z-Brace Mounted Rear Robotics] [Gulfcoast Kit Printers 3D Plus Select Maker and Plus i3 Duplicator Wanhao for 3D Printer Accessories

allow the radiator to cool. test the temperature of the radiator by carefully touching the radiator hose; do not continue if the radiator hose is still hot.

step 2

cover the radiator cap with a towel or rag, and slowly twist the cap to open the radiator. let any steam dissipate before fully opening the radiator.

step 3

crack an egg gently into two halves over the bowl. pour the yolk back and forth between the shell halves, and let only the white run into the bowl.

step 4

pour the egg white from the bowl into the radiator.

step 5

repeat steps 3 and 4 for the remaining eggs. separate and pour the whites into the radiator one at a time; if you spill the yolk, you won't ruin all of the whites.

screw the cap radiator cap back into place, and make sure it is secure before starting your car.

more articles

how to test a radiator for blockage
how to change antifreeze in a camry

Support Frame Z-Brace Mounted Rear Robotics] [Gulfcoast Kit Printers 3D Plus Select Maker and Plus i3 Duplicator Wanhao for 3D Printer Accessories

×
SYRENESAXOFOONKWARTET.NL RSS