1. Home
  2. Motor 2x10A Cytron Driver RPI for HAT
  1. facebook
  2. twitter
  3. linkedin
  4. pinterest
Cytron 2x10A Motor Driver HAT for RPI

HAT-MDD0 is designed to drive two high current brushed DC motor up to 0A continuously by using Raspberry Pi as the controller.


-Bi-directional control for two brushed DC motor.

-Support motor voltage ranges from 6VDC to VDC.

-On board test button for manual control of motor.

-Every channel output built with LED indicator.

-Maximum current up to 0A continuous (without heatsink at 5℃) and 30A peak (0 second).

-Current limiting at 30A.

-Raspberry Pi compatible connector.

-Solid state components provide faster response time.

-Fully NMOS H-Bridge for better efficiency and no heat sink is required.

-Speed control PWM frequency up to KHz (Actual output frequency is same as input frequency from Raspberry Pi).

-Support sign-magnitude PWM operation.

-Support TTL PWM from microcontroller, not PWM from RC receiver.

-Dimension:67.5mm x 59mm

-Made In Malaysia

Motor 2x10A Cytron Driver RPI for HAT Scientific Gifts

by william nagel

the radiator keeps your vehicle's engine cool during a drive; but when your radiator is leaking coolant, the engine can overheat and suffer serious damage. if you are far from a garage and your radiator is leaking, you can use eggs to patch small holes and temporarily plug the leaks. heat from the radiator will cook the egg whites, and pressure will force the eggs into the holes, fixing the leaks long enough to take your car to a garage for repairs.

Motor 2x10A Cytron Driver RPI for HAT Scientific Gifts

allow the radiator to cool. test the temperature of the radiator by carefully touching the radiator hose; do not continue if the radiator hose is still hot.

step 2

cover the radiator cap with a towel or rag, and slowly twist the cap to open the radiator. let any steam dissipate before fully opening the radiator.

step 3

crack an egg gently into two halves over the bowl. pour the yolk back and forth between the shell halves, and let only the white run into the bowl.

step 4

pour the egg white from the bowl into the radiator.

step 5

repeat steps 3 and 4 for the remaining eggs. separate and pour the whites into the radiator one at a time; if you spill the yolk, you won't ruin all of the whites.

screw the cap radiator cap back into place, and make sure it is secure before starting your car.

more articles

how to test a radiator for blockage
how to change antifreeze in a camry

Motor 2x10A Cytron Driver RPI for HAT Scientific Gifts